You are editing:
/usr1/www/Optics/html/components/PEN-ETM_03.txt
# ************************************************************* # # Component: PEN-ETM_03 # # Enter data or descriptions for any of the parameters in the # DATA PARAMETERS section below. # Type on the same line as the parameter, leaving 1 or more # spaces between the parameter name and your text. # # Quotes are not required. # # You may include comment lines, beginning with the character # "#", anywhere you like. # # You may include simple html tags (i.e. <br> to insert a # line break) to format your content, but all content must # be on ONE LINE. # # All values do not need to be populated, but the parameter # names should NOT BE CHANGED OR DELETED! # ************************************************************* #-------------------------------------------------------------- # Units "Cheat sheet": # # optic-type: any one of these: # ITM ETM CP ERM FM BS PRM PRM-w F-PRM PR2 # F-PR2 PR3 F-PR3 SRM F-SRM SRM-w SR2 F-SR2 SR3 # IMCC IMCF # # sn: integer # ROC: meters (floating point number) # figure: nm rms (floating point number) # thickness (max): mm (floating point number) # diameter: mm (floating point number) # mass: grams (floating point number) # wedge: degrees (floating point number) # vendor-polish: DCC Number(s) # vendor-coating: DCC Number(s) # vendor-substrate: DCC Number(s) # scatter: ppm (floating point number) *and/or* DCC Number(s) # absorption: ppm (floating point number) *and/or* DCC Number(s) # HR: ppm (floating point number) *and/or* DCC Number(s) # AR: ppm (floating point number) *and/or* DCC Number(s) # drawings: DCC Number(s) # notes: freeform text # status: freeform text # location: freeform text # # IMPORTANT - # Measurements should include tolerance! # #-------------------------------------------------------------- # # DATA PARAMETERS # optic-type PEN-ETM sn 03 ROC X figure X thickness diameter mass 39621 wedge vendor-polish Q1100027 vendor-coating X vendor-substrate scatter X absorption X HR X AR X drawings D080117 notes status red 4mm crack developed under S4 prism during welding 6/20/13 and opened completely during welding 5/2018 was H1-ETMX - No recovery unless new flats are installed. location CIT # These two are the rightmost "hinting" columns optic-typeX PEN-ETM snX 03